Technical Information
 |
 |
 |
1. Measure the length of
the creasing rule |
|
2. Mark the measurement
and cut the matrix |
 |
|
 |
3. Mount the cut piece onto
the creasing rule with locator |
|
4. Repeat cutting and mounting onto all the creasing rules |
 |
|
 |
| 5. Clean the counter plate to remove any residue from the previous job |
|
6. Remove all the backing tapes |
 |
|
 |
7. Transfer the matrix and the
locator onto the counter plate |
|
8. Remove all of the locators |
 |
- Firstly measure the board thickness 'C' - up to 700 gsm
- Multiply the thickness 'C' by 1.5.
- Add on the crease rule thickness 'D' (see table below).
- This will give you measurement 'B'.
- Find the correct width of MATRIX closest to measurement 'B'.
- Measurement 'A' should be equivalent to the thickness 'C', though it may need adjusting with rule height.
|
 |
- Firstly measure the compressed thickness of the board 'E'
- Multiply the thickness 'E' by 2.
- Add on the crease rule thickness 'D'.
- This will give you measurement 'B'.
- Find the correct width of MATRIX closest to measurement 'B'.
- Measurement 'A' should be equivalent to the thickness 'E', though it may need adjusting with rule height.
|
 |
- Firstly measure the width required between creases from centre to centre (Z).
- Subtract the rule width (see table below).
- This will give the measurement 'Y'. Choose the matrix closest to this.
- To calculate measurement 'X', multiply the board thickness 'C' by 1.5
- Take this measurement away from 'Y' to derive the matrix size closest to.
|
 |
- Follow steps 1-3, as shown above for solid board to calculate measurement 'Y'.
- To calculate the measurement 'X', firstly measure the board thickness 'E', and multiply x 2.0.
- Take this away from measurement 'Y' to derive the matrix size closest to.
|
| |
|
Point Size
|
Width (mm)
|
|
1.5
|
0.52
|
|
2.0
|
0.71
|
|
3.0
|
1.05
|
|
4.0
|
1.42
|
|
6.0
|
2.10
|
|
